>>> TILBUD TILBUD TILBUD - 25% PÅ ALT VIKING FILAMENTS FILAMENT 25% - TILBUD TILBUD TILBUD <<<
Priserne er inklusiv moms
Ikke på lager
Advarsel: Sidste enheder på lager!
Skriv din e-mail-adresse her, hvis du vil have besked når vi igen har denne vare på lager:
Jeg ønsker en e-mail når varen kommer på lager
BLTouch is an auto levelling sensor for 3D Printers that can precisely measure the tilt of bed surface. It could work with any kinds of bed materials, such as glasses, woods, metals, and so on.
CR Series: CR-10, CR20 Pro
Ender Series: Ender-3, Ender-3X, Ender-3 Pro, Ender-5, Ender-5 Pro
This kit is not intended for the CR-10S Pro!
Main functions and controls of BLTouch are the same as usual auto bed levelling sensor, consists of RC servo and micro switch. Thus, BLTouch can be applied on almost every board.
BLTouch is fulfilled with simple structure and high precision by using progressively designed solenoid and hall sensor. It aims for user convenience and enjoyable printing by adding many smart functions, such as self-test, alarm, alarm release & Touch Switch mode, Blue LED for servo signal indicating and Z-probe (Z-min) Testing.
Self-test: The push pin operate two times in a test when the power is on.
Alarm: The LED light blinks if a problem was found on a self-test or during operation
Wiring defect indicator: Blue and Red LED for indicating wiring defects.
This kit comes with a 1.5-meter extension cable suitable for the Ender 3, Ender 5 and CR-10
Click here to download the firmware needed to enable BLTouch functionality
Please note that on some models you need to reverse the polarity of the Z-limit cable. This is done by swapping the white and back cables around.
|Spare Parts Category||ELEKTRONIK|